150 ton sunflower oil production line

150 ton sunflower oil production line

Sunflower oil press process

1.After cleaning , cooking , then pressing

Pressing process: Adopt the largest LD28 prepress machine in China to squeeze out some of the oil from the highoil materials, such as sunflower seed etc., to meet the following cake extraction requirements. The dry cake is loosestructured and not broken, easy for solvent premeability, with low residual oil and low running cost.

2. Leaching process :

1. Adopt stainless steel fixed grid plate and increase the horizontal grid plates, which can prevent the strong miscella from flowing back to the blanking case, so as to ensure good extraction effect

2. Its Rotocel extractor is driven by rack, with unique rotor of balanced design, low rotating speed, low power, smooth operation, no noise and quite low maintenance cost;

3. The feeding system can adjust the rotating speed of airlock and main engine according to the feeding quantity and maintain a certain material level, which is beneficial to the micro negative pressure inside the extractor and reduce the solvent leakage.

4. The advanced miscella circulation process is designed to reduce the fresh solvent inputs, reduce the residual oil in meal, improve the miscella concentration and save energy by reducing the evaporation capacity.

5. The high material layer of the extractor helps to form immersion extraction, reduce the meal quality in miscella, improve the quality of crude oil and reduce the evaporation system scaling.

6. Specially suitable for the extraction of various pre-pressed meals.

Wet Meal Desolventizing Process

The desolventizer has the three layers , the first layer is pre - desolventizing layer . The second layer is ventilating layer .

The third is desolventing layer . The fourth layer is drying layer . The fifth layer is cooling layer .This process of pre - desolventizing , we use the indirect steam to heat , the temperature is 70 -80degree .

Then the cake enter the ventilating layer , the size of hole is 25-30 mm , the we can open the hole by the steam , which make us easily make the solvent evaporate .

The desolventizer layer , the temperature is 107- 108 degree ,this layer , we mainly remove solvent by the superheat steam Then the cake enter the drying layer , the process , its temperature is 110 - 120 degree , and this process we can make the moisture is 12.8-13.2 in the meal .

Then the cake enter the cooling layer , cooling the temperature to understand 40 degree . And in the meal , the solvent residual is less than 500 ppm

--engineer available send to over seas to help you install the equipment

--engineer train workers untill your machine shall work well

--engineer shall make special design for you

.............................................................................................................................................................................

--we update our new technology for you

--one year warranty

.............................................................................................................................................................................

--if you have any questions, pls contact us at any time

--if you have difficulte to operate the machine, technician aviable to fly your country to give you a hand

--we supply the important parts if you can not buy from local